INFICON SKY CDGxxxD (Profibus) - Manual (Page 40)

40
tira54e1-a (2009-01) CDGxxxD.cp
The following attributes are supported:
ID Name Structure Data type Bytes Access Store See section
16 Block Type ID Simple OSTRING(n) 4 1_R
2_R N 11.2.1
19 Low Trip Point Simple According
Data Type
value (ID 29) - 1_R/W
2_R/W
N 11.2.2
20 Low Trip Enable Simple Boolean 1 1_R/W
2_R/W N 11.2.3
21 Status Simple UINT8 1 0_XI
1_R
2_R D 11.2.4
24 Hysteresis Simple According
Data Type
value (ID 29) - 1_R/W
2_R/W
N 11.2.5
27 Analog Input
Sensor Function
Block Instance
Simple UINT8 1 1_R
2_R
N 11.2.6
28 Data Units Simple UINT16 2 2_R/W N 11.2.7
29 Data Type Simple UINT8 1 2_R/W N 11.2.8
201 Percentage of
ATM
Simple FLOAT 4 1_R/W
2_R/W N 11.2.9
202 High Trip Point Simple According
Data Type
value (ID 29) - 1_R
2_R
N 11.2.10
203 High Trip Enable Simple Boolean 1 1_R
2_R N 11.2.11
The Block Type ID Parameter contains an ID which describes the block type. The
block type ID of the "Trip Point Function Block" is set to "17". The other defined
block types are listed in Appendix B.
This parameter defines the value at or below which a trip point condition will occur.
This parameter enables/disables the Low Trip Point setting.
Parameter value Description
0 disable Low Trip Point setting
1 enable Low Trip Point setting
This parameter contains the state of this object instance. The functionality is
described in section 11.1.
Parameter value Description
0 trip point condition does not exist
(unasserted)
1 trip point condition exists
(asserted)
11.2 Trip Point Function
Block (Relay 1 and
Relay 2)
11.2.1 Block Type ID (ID 16)
11.2.2 Low Trip Point (ID 19)
11.2.3 Low Trip Enable (ID 20)
11.2.4 Status (ID 21)