Kinze 3700 Front Folding Planter Rev. 7/14 - Manual (Page 120)

M0233-01 Model 3700
5-24 Rev. 10/11
TM
Lubrication and Maintenance
granULar CheMiCaL aTTaChMenT
Before storing planter, disengage granular chemical drive by
rotating throwout knob ¼ turn counterclockwise. Remove drive
chain and empty and clean all granular chemical hoppers.
Clean drive chains and coat them with a rust preventive spray
or submerge chains in oil. Inspect and replace worn or broken
parts.
Install hoppers and chains. Check chain alignment.
Disengage
Engage
granular chemical throwout knob
Spring TOOTh inCOrpOraTOr
Before storing planter, inspect each spring tooth incorporator
and replace worn or broken parts. Check for loose hardware
and tighten as needed.
Spring tooth incorporator
1. Remove ¼"-20 x ½" cap screw securing idler with sprockets to wrench tightener shaft and remove wrap spring
wrench from planter.
2. Remove split rings and disassemble as shown above. Soak metal parts in solvent and thoroughly clean.
nOTe: L.h. and r.h. release collars and torsion springs are different. Order correct parts for each assembly.
3. Replace damaged parts. Lubricate parts with high quality silicon lubricant and reassemble.
4. Reinstall wrap spring wrench on planter.
wrap Spring wrenCh CLeaning and repair
Torsion spring
⅞ "external
inverted snap ring
⅞ "external inverted snap ring
1½" external
inverted snap ring
1½" external inverted snap ring
Sleeve
Release collar
⅞ "external inverted snap ring
Tightener shaft
Handle (vinyl grip not shown)