Landoll BPSB6 Till-N Seed - Manual (Page 13)

SAFETY INFORMATION
1-9
Figure 1-7: Decals (2 of 2)
CALIBRATION CHART
P/N 3P076
TRANSMISSION LAYOUT
P/N 3P160
SEED DRIVE
DISCONNECT
PIN - FRONT BOX
LEFT END VIEW OF MACHINE
5/8" HEX FOR
FRONT BOX
CALIBRATION
TURN CW
5/8" HEX FOR
REAR BOX
CALIBRATION
TURN CCW
FRONT ROTOR AXLE
HIGH
RANGE
MID
RANGE
LOW
RANGE
19T DRIVER
23T DRIVEN
23T DRIVEN
37T DRIVEN
13T DRIVER
10T DRIVER
CALIBRATION TROUGH:
SEEDING POSITION
SEED DRIVE
DISCONNECT
PIN - REAR BOX
VIEW FROM INSIDE OF LEFT END PLATE
CALIBRATION TROUGH:
COLLECTION POSITION
TRANSMISSION LAYOUT
3P160 FOR TILL 'N SEED
3P076 FOR TILL 'N SEED
SEED RATE CALIBRATION
PLACE CALIBRATION TROUGH IN COLLECTION POSITION OR PLACE TARP UNDER
FRONT OF MACHINE. REFER TO SEED CHARTS ON THE SEED BOX COVERS TO
DETERMINE INITIAL SEED METER SETTINGS. IF YOU NEED TO ADJUST SEED
METERS FOR REDUCED OUTPUT WHILE THEY ARE FILLED WITH SEED, THE SEED
METER SHAFT MUST BE TURNED WHILE MAKING THE ADJUSTMENT.
FRONT SEEDBOX
1. IDENTIFY LOWEST TRANSMISSION RANGE EXPECTED TO ACHIEVE SEED RATE
2. ADJUST SEED METER SETTING
3. REMOVE SEED DRIVE DISCONNECT PIN - FRONT BOX
4. PRIME METERS: TURN 5/8" HEX FOR FRONT BOX CALIBRATION CW UNTIL ALL
METERS ARE DISCHARGING SEED. EMPTY CALIBRATION TROUGH OR TARP
5. COUNTING REVOLUTIONS, TURN THE 5/8" HEX CW TO METER OUT SEED
6. WEIGH THE SEED
7. CALCULATE SEED RATE:
LBS OF SEED x A 252 (LOW RANGE)
SEED RATE (LBS / ACRE) = ------------------------------ A= 528 (MID RANGE)
CALIBRATION REVS 771 (HIGH RANGE)
8. ADJUST METERS AND RE-CALIBRATE AS NECESSARY
9. ENSURE TRANSMISSION IS SET UP FOR PROPER SEEDING RANGE
10. RE-INSTALL SEED DRIVE DISCONNECT PIN - FRONT BOX
11. RE-INSTALL CALIBRATION TROUGH IN SEEDING POSITION
REAR SEEDBOX
1. ADJUST SEED METER SETTING
2. REMOVE SEED DRIVE DISCONNECT PIN - REAR BOX
3. PRIME METERS: TURN 5/8" HEX FOR REAR BOX CALIBRATION CCW UNTIL ALL
METERS ARE DISCHARGING SEED. EMPTY CALIBRATION TROUGH OR TARP
4. COUNTING REVOLUTIONS, TURN THE 5/8" HEX CCW TO METER SEED
5. WEIGH THE SEED
6. CALCULATE SEED RATE:
LBS OF SEED x 143
SEED RATE (LBS / ACRE) = -------------------------------
CALIBRATION REVS
7. ADJUST METERS AND RE-CALIBRATE AS NECESSARY
8. RE-INSTALL SEED DRIVE DISCONNECT PIN - REAR BOX
9. RE-INSTALL CALIBRATION TROUGH IN SEEDING POSITION
FRONT