Landoll BPSB6 Till-N Seed - Manual (Page 33)

3-1
Chapter 3
Optional Equipment Instructions
Acre Meter Kit 3P099 Installation
The Acre Meter Kit consists of four main parts; Acre
Meter Assembly, Pick-up Switch Bracket, Pick-up Switch,
and Magnet Wheel.
1. Remove 3/8-16 Hardware from Acre Meter
Assembly. Use the Acre Meter Bracket as a guide
and drill two 13/32" holes into the seedbox. Insert
hardware and Tighten.Attach Pick-up Switch Bracket
to the Lower Frame with 5/16-18 Hardware.
2. Attach Pick-up Switch to Bracket with #8-32
Hardware. Do not tighten at this time.
3. Attach ground wire with #6-32 Hardware, removing
paint under the wire connector to assure a good
electrical ground connection.
Figure 3-1: Acre Meter (1 of 2)
HHCS,3/8-16 x 1
Lock Washer,3/8
Nut,Hex 3/8-16
Acre Meter
Assembly
Acre Meter Bracket
Magnet Wheel
Magnet Wheel
Set Screw
HHCS,5/16-18 x 1
Lock Washer,5/16
Nut,Hex 5/16-18
Pick-up Switch
Rnd Hd,#6-32 x 1/2
Nut,Hex #6-32
Nut,Hex #8-32
Lock Washer,#8-32
Flat Washer,#8-32
Rnd Hd,#8-32 x 1-1/4
Pick-up Switch
Bracket
Drive Shaft
Pick-up Switch
Ground Wire