Landoll BPSB6 Till-N Seed - Manual (Page 34)

3-2 3P091
OPTIONAL EQUIPMENT INSTRUCTIONS

WARNING
4. Press or slide Magnet Wheel onto Drive Shaft until it
is vertically centered with the Pick-up Switch.
5. Adjust the Pick-up Switch so the centerline of Magnet
Wheel and Pick-up Switch are horizontally and
vertically aligned with a maximum 1/8" gap between
them. Firmly tighten Switch to bracket and tighten set
screw (if present) in Wheel.
Alignment of Pick-up Switch and Magnet Wheel is
critical. Improper alignment will cause the Acre Meter to
record acres erratically or not at all.
6. Route Pick-up Switch Cable up to the Acre Meter
Cable and connect mating plugs.
7. Securely fasten cable to frame using the
adhesiveCable Tie Mounting Base and Cable Ties to
prevent cable from becoming entangled or rubbing
on moving parts.
8. Program Acre Meter per the following instructions on
the next page.
Figure 3-2: Acre Meter (2 of 2)
Do Not Pressure Clean With Air Or Water.
H
1/8” max
Magnet
Wheel
Pick-up
Switch
Bracket
Bracket
Drive Shaft
Connect Plugs
and bundle cables
together neatly and
cable tie
Adhesive Cable
Tie Mounting
Base
Cable Tie
Adhesive Cable
Tie Mounting Base
Cable Tie
Pick-up
Switch Cable