Lenze 931K - Manual (Page 15)

Commissioning
Configuration with an EtherCAT configuration tool
6
l
15 KHB 13.0005−EN 1.0
6 Commissioning
6.1 Configuration with an EtherCAT configuration tool
For commissioning the EtherCAT network the following configuration tool is required:
ƒ Lenze »Small Drives Control SDC«
This is a software system for real−time execution, programming, configuration, and
diagnostics of control programs.
ƒ The basic parameters of the EtherCAT bus system are stored in the internal
configuration memory and can be used by the master for the node detection.
ƒ During the search for nodes (bus scan) the corresponding device descriptions are
used.