Lenze E82ZMFBC001 - Manual (Page 43)

Mechanical installation
Motor mounting
4
EDK82ZMFBC-001 DE/EN/FR 7.0
43

H1_MechINS-E82ZMFB_BusIO
0
E82ZMFB004
4. Press the fieldbus function module into the fixing frame until it snaps into place.
5. Remove the cover of the terminal strip
.
0
E82ZMFB005
6. Wire the fieldbus function module.
– Remove approx. 10 cm of the cable sheath.
– Connect the shield to the shield sheet using the cable tie.
– Wire the fieldbus function module (see corresponding Mounting Instructions).
Terminal 28 (controller inhibit) of the fieldbus function module isinactive.Controller
is inhibited via terminal 28 of the bus-I/O function module.