Lenze E82ZMFBC001 - Manual (Page 52)

5 Electrical installation
Wiring
EDK82ZMFBC-001 DE/EN/FR 7.0
52

H1_E_INST-INS_Klemmenbeleg
X3/ Signal
type
Function
(Lenze setting: bold print)
Level
(Lenze setting: bold print)
62 Analog
output
Output frequency 0 … +6 V
0 … +10 V 1)
7 - GND1, Reference potential for analog signals -
8 Analog
input
Input for actual value or setpoint
Switch over the range with the DIP switch and in C0034:
z Voltage signal 0 … +5 V
0 … +10 V
-10 … +10 V 2)
z Current signal 0 … +20 mA
+4 … +20 mA
+4 … +20 mA (open-circuit
monitored)
9 - Internal, stabilised DC voltage source for the
setpoint potentiometer
+5.2 V
20 - Internal DC voltage supply for control of digital
inputs and outputs
+20 V ±10 % (ref.: X3/7)
28
Digital
inputs
Controller inhibit (CINH) 1 = enable
E1 3) Activation of JOG frequencies
JOG1 = 20 Hz
JOG2 = 30 Hz
JOG3 = 40 Hz
e1 E2
JOG1 1 0
E2 3) JOG2 0 1
JOG3 1 1
E3 DC-injection brake (DCB) 1 = DCB
E4 Change of direction of rotation
CW/CCW rotation
E4
CW 0
CCW 1
39 - GND2, Reference potential for digital signals -
A1 Digital
output
Ready for operation
z internal supply:
z external supply:
0 … +20 V
0 … +24 V
59 - DC supply for X3/A1
z internal (bridge to X3/20):
z external:
+20 V
+24 V
1) Output level 0 … +10 V: Adapt offset (C0109/C0422) and gain (C0108/C0420)
2) Adjust offset (C0026) and gain (C0027) separately for each function module ...
- after replacing the function module or the basic device.
- after loading the Lenze setting.
3) Frequency input alternatively 0 … 10 kHz single-track or 0 ... 1 kHz two-track, config. via C0425