Lenze E82ZMFBC001 - Manual (Page 47)

Mechanical installation
Wall mounting
4
EDK82ZMFBC-001 DE/EN/FR 7.0
47

H1_MechINS-E82ZMFB_BusIO
Mounting
1. Mount the housing shell to the mounting plate using the 2 self-tapping screws
5 × 18.
2. Mount the cable glands M16 using a 10 mm thread length.
3. Screw the fixing frame for the fieldbus function module into the housing shell using
2 self-tapping screws 3 × 10.
4. Press the fieldbus function module into the fixing frame until it snaps into place.
5. Remove the cover of the terminal strip.
6. Wire the fieldbus function module.
– Remove approx. 10 cm of the cable sheath.
– Connect the shield to the shield sheet using the cable tie.
– Wire the fieldbus function module (see corresponding Mounting Instructions).
Terminal 28 (controller inhibit) of the fieldbus function module isinactive.Controller
is inhibited via terminal 28 of the bus-I/O function module.
E82ZMFB006
7. Mount motec carrier housing
– Break out holes at the predetermined breaking points .
– Insert 2 screws M5 × 20 through holes  and 2 self-tapping screws 5 × 55 through
holes .
– Screw motec carrier housing onto the housing shell.