Lenze EVF9383−EV - Manual (Page 17)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
3
l
17 EDKVF93−05 EN 2.0
Function keys
)
Note!
Shortcuts with
T:
Press and hold
T, then press the second key in addition.
Key Function
Menu level Code level Parameter level Operating level
V
Change to the
parameter level Change to the operating
level Change to the code
level
T V
Go to the "Short setup"
menu and load
predefined
configurations
1)
Accept parameters
when SHPRG
p or
SHPRG is displayed
z
y
Change between menu
items
Change of code number
Change of digit via
cursor
T z
T y
Quick change between
menu items Quick change of code
number Quick change of digit
via cursor
Z
Change between main menu, submenu and code
level
Cursor to the right
Y Cursor to the left
U Deactivate the function of the key S, the LED in the key goes off
S Inhibit the controller, the LED in the key is lit.
Reset fault (TRIP−Reset): 1. Remove the cause of malfunction
2. Press S
3. Press U
1) Only active for operation with standard devices of the 8200 vector or 8200 motec series
3.1.4 Changing and saving parameters
)
Note!
Your settings have an effect on the current parameters in the main memory.
You must save your settings in a parameter set so that they are not lost when
the mains are connected.
If you only need one parameter set, save your settings as parameter set 1,
since parameter set 1 is loaded automatically after mains connection.
Step Key
sequence Action
1. Select the menu z y Z Y Use the arrow keys to select the desired menu
2. Change to the code level Z Display of the first code in the menu
3. Select code or subcode y z Display of the current parameter value
4. Change to the parameter level V
5. When SHPRG is displayed, inhibit the
controller S 1) The drive coasts
6. Change parameter
A Z Y Move cursor below the digit to be changed
B y z Change of digit
T y
T z
Quick change of digit
7. Accept the changed parameter