MK Diamond MK-100 JCS - Manual (Page 16)

MK-100 JCS Tile Saw Revision 06/05, Effective Date June 27, 2005
UNPACKING, TRANSPORT, JCS STAND and ASSEMBLY
ASSEMBLY:
Follow the assembly instructions to prepare your MK-100 for operation.
1. Cutting Head Installation:
NOTE: If the Cutting Head is installed, go to step 2.
2. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the screw.
(A)
Remove Adjusting Knob
(B)
Align Cutting Head rear Pivot
Hole to the Post, Pivot Shaft
(C)
Install the Cutting Head onto the
Post, Pivot Shaft and Install
The Adjusting Knob
Turn Counter-
clockwise to remove
Rear Pivot
Hole
Pivot Shaft
Post Turn Clockwise
to tighten
(A)
Position Movable Cutting Table
to the front of the saw and
raise the Blade Guard
(C)
Depress and hold the Shaft Lock
pushbutton and remove Retaining
Screw and Outer Flange using
the Blade Wrench
(D)
Install Diamond Blade
onto Blade Shaft
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock pushbutton
and Tighten
Pivot Blade
Guard up Tighten
Wing-nut
Movable
Cutting Table
Turn counter-
clockwise to
loosen
Press and
Hold
Retaining Screw
and Outer Flange
Diamond
Blade
Blade
Shaft
Rotation Direction
Retaining
Nut and
Outer Flange
Rotate Blade
Wrench clockwise
to tighten
(B)
Locate the Shaft Lock
pushbutton on the underside
of the Cutting Head
Cutting
Head
Shaft Lock
Pushbutton
Blade
Wrench