MK Diamond MK-100 JCS - Manual (Page 29)

MK-100 JCS Tile Saw Revision 06/05, Effective Date June 27, 2005 Page 29
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE:
1. New Maintenance:
Perform the following after initial purchase and operation of the MK-100.
2. Maintenance Following Use:
To extend the life of the MK-100, the following procedure should be performed after each use. Lubricate all
points listed below with light oils such as, 3 in 1, WD-40, etc.
(A)
Check and adjust V-belt
tension Following 1
st
48 hours of
operation (See V-belt Inspection)
(A)
Ensure the ON/OFF Switch
is in the OFF position
Off
Position
ON/OFF
Switch
(B)
Unplug MK-100
(C)
Lubricate the Guide Bar
(A)
Lubricate the Roller
Wheel Assembly
Inspect
V-belt
GFCI Guide Bar
Roller Wheel
Assembly