MK Diamond MK-100 JCS - Manual (Page 33)

MK-100 JCS Tile Saw Revision 06/05, Effective Date June 27, 2005
MAINTENANCE AND TROUBLESHOOTING
2. Diamond Blade Change-out:
NOTE: When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the screw.
(C)
Remove the Diamond Blade
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
Diamond
Blade
Rotation Direction
(D)
Install the Diamond Blade
onto Blade Shaft
Diamond
Blade
Blade
Shaft
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock pushbutton
and tighten
Retaining
Nut and
Outer Flange
Rotate Blade
Wrench clockwise
to tighten
(A)
Locate the Shaft Lock
pushbutton on the underside
of the Cutting Head
Cutting
Head
Shaft Lock
Pushbutton
(B)
Remove Retaining Nut and
Outer Flange, depress
and hold the Shaft Lock
pushbutton and loosen
Retaining
Nut and
Outer Flange
Rotate Blade
Wrench counter-
clockwise to loosen