MK Diamond MK-100 JCS - Manual (Page 25)

MK-100 JCS Tile Saw Revision 06/05, Effective Date June 27, 2005
SETUP, ADJUSTMENT and OPERATION
5. Adjusting the Cutting Head:
The Cutting Head is heavy! Care must be used when changing the position of the Cutting Head.
(C)
Remove Adjusting Knob
(A)
Ensure the ON/OFF Switch
is in the OFF position
Off
Position
ON/OFF
Switch
(B)
Unplug the GFCI from the
power source
(F)
Install the Adjusting Knob
(D)
Remove the Cutting Head from
The rear pivot hole
(E)
Install the Cutting Head onto
the front pivot hole
(G)
Set cutting depth approximately
1/4 to 1/2 inch below the surface
of the Movable Cutting Table
(H)
Plug the GFCI into the
power source
Unplug
Turn Counter-
clockwise to remove
Remove
Cutting Head
Rear Pivot
Hole
Front Pivot
Hole
Turn Clockwise
to tighten
GFCI Plugged
Into Power
Source
Adjust Cutting
Head to Cut Depth
of Approx ¼” to ½”