MK Diamond MK-112 - Manual (Page 16)

16
SETUP, ADJUSTMENT & OPERATION
ADJUSTMENT & OPERATION
1. Cutting at 90°:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
In order to make any diagonal cuts, position the tile against the cutting guide as shown in PICTURE 8.
PICTURE 8
Thanks to the great versatility of the MK-112 Saw it is possible to carry out different types of cuts.
Take the blade to the 0° position with the angle adjustment knobs (See PICTURE 6). Position the tile on the
support table and make sure that it is properly positioned against the cutting guide.
THE RULER PLACED ON THE WORKING TABLE HELPS ONLY WITH RIP CUTTING
PICTURE 6 PICTURE 7
Angle Adjustment Knob
CAUTION
CAUTION