MK Diamond MK-112 - Manual (Page 17)

17
SETUP, ADJUSTMENT & OPERATION
2. Cutting 45° Miters:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
The MK-112 is designed with an adjustable Cutting Head for precision 45º Miter Cuts.
Take the blade to the 45° position with the Angle Adjustment Knobs (See picture 11).
Lock the motor carriage at the max. cutting depth with the locking lever (See Picture 10). Picture 10 shows the
proper way the machine should be used.
With the MK-112 Saw, it is possibe to set out:
a. the cutting length with the cut length adjustment knobs (See PICTURE 9)
b. the cutting depth with the locking lever (See picture 10)
PICTURE 11
Before any cutting, make sure that the tile to be cut is properly positioned against the cutting guide.
PICTURE 9 PICTURE 10
Cut Length Adjustment Knobs
Locking Lever
Angle Adjustment Knob
CAUTION
CAUTION