MK Diamond BX-3 - Manual (Page 13)

13
UNPACKING:
Your BX-3 has been shipped from the factory thoroughly inspected. Only minimal assembly is required.
If not already done, remove the BX-3 from the carton and place it on a flat surface. Remove Strapping.
Remove the Accessories box from the main carton and place along side the BX-3 (Owners Manual is in
Accessories Box).
CONTENTS:
In the containers, you will find one (1) BX-3, one (1) 14 inch segmented dry diamond blade (or segmented
block blade), one (1) movable cutting table, one (1) adjustable cutting guide, one replacement motor air filter,
one (1) blade wrench, one (1) shaft wrench, one (1) owner's manual and one (1) warranty card.
BX-3 Segmented Dry
Diamond Blade
Adjustable
Cutting Guide
Movable Cutting
Table
Extra Motor
Air Filter
Blade
Wrench
Shaft
Wrench
Owner's
Manual
Warranty
Card
TRANSPORT:
The BX-3 weighs approximately forty (45) pounds (Without the Movable Cutting Table), making transport easy.
Always observe safe lifting practices when lifting the BX-3.
NOTE: Lock the Cutting Head in the DOWN position, and remove the Movable Cutting Table when
transporting the BX-3.
Due to its lightweight construction, the BX-3 is designed to be carried by the durable aluminum frame. Simply
lock the spring assisted cutting head in the DOWN position, grasp the frame by the lower front and upper
back cross members, lift and transport the BX-3 to the desired work location
Lift Point
Cutting Head
Locked Down
- OR -
Locking Pin
Inserted
09.2011
BX-3 MASONRY SAW OWNERS MANUAL, PARTS LIST & OPERATING INSTRUCTIONS
www.diamondvantage.com
Caution: Read all safety and operating instructions before using this equipment. This owners manual MUST accompany the equipment at all times.
Revision 100 Manual Part No. 158168-DV
BX-3 CONTENTS