MK Diamond BX-3 - Manual (Page 19)

19
5. Angle Cuts:
Angle Cuts may be performed using the Step Cut, Chop Cut or the Locked Cutting Head cutting methods.
The following is utilizing the Locked Cutting Head method.
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which it was designed.
(A)
Remove Adjustable
Cutting Guide
(B)
Reposition Adjustable
Cutting Guide
(C)
Position Adjustable
Cutting Guide
(E)
Locked Cutting Head Setup
(D)
Lock Cutting Head in
the Down Position
(I)
Release Cutting Head
(G)
Continue Pushing Piece into
Blade until Cut Complete
(F)
Slowly Push Piece toward Blade
to Begin the Cut
(H)
Cutting Complete
Remove Adjustable
Cutting Guide
Turn to Loosen
Ruler/Stop
Align 45° Slots
to Ruler/Stop
Ruler/Stop
Set against Adjustable
Cutting Guide and
Ruler/Stop
Align Holes and
Lock Cutting
Head in Position
Lock Trigger Switch
Hold Work
in Position Push Slowly to Cut
Continue to Push
until Cut Complete
Unlock Trigger
Switch when
Cut Complete
Remove Locking
Pin to Release
Cutting Head Hold in Position
Unlock Trigger
Switch when
Cut Complete
Allow Blade to
Stop Before
Removing Work
Adjustable
Cutting Guide
BX-3 ADJUSTMENT