MK Diamond BX-3 - Manual (Page 14)

14
ASSEMBLY:
Follow the assembly instructions to prepare your BX-3 for operation.
1. Movable Cutting Table Installation:
2. Adjustable Cutting Guide Installation:
3. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the screw.
(C)
Seat and Tighten
Adjustable Cutting Guide
(B)
Position Adjustable Cutting Guide
Rotate Blade
Wrench Clockwise
(C)
Verify Correct Seating
(A)
Loosen Thumbscrew
(B)
Remove Retaining Screw
and Outer Flange
(A)
Identify Retaining Screw
and Outer Flange
(D)
Install Retaining Screw and
Outer Flange - Tighten
(C)
Install and Seat Blade –
Verify Rotation
(B)
Seat Roller Wheels on
Guide Rails
(A)
Position Movable Cutting Table
Ease of Movement
(See Maintenance Section
If Problems Arise)
Seated
Cutting Table
Front
Roller Wheels
Guide Rail
Guide Rails
Roller Wheels
Ruler/Stop
Align
Parallel Slots
Turn to Tighten
Retaining Screw Motor Shaft
Hold Shaft
Wrench
Stationary
Rotate Blade
Wrench
Counter-clockwise
Outer Flange
Seat Blade on
Inner Flange
Rotation Direction
Hold Shaft
Wrench
Stationary
Turn to Loosen
BX-3 ASSEMBLY