MK Diamond MK-1600 Series - Manual (Page 19)

19
MK-1600 OPERATION
Standard Operation
The MK-1600 is intended for industrial applications and operated by experienced professionals. The
operator must be aware of the machine’s capabilities and limitations. It is the operators responsibility
to use this machine under safe working conditions and conform with federal, state and local codes or
regulations pertaining to safety, air, pollution, noise etc...
(A)
Use the Depth Control Wheel to
raise the blade clear of the floor.
(B)
Attach the cooling supply
hose to the Cooling Inlet, if
wet cutting.
(C)
Lower the Pointer. Using a Straight-
edge, align the Pointer to the Blade
see “Front Pointer Alignment.”
(E)
Place Engine Master Switch in
the “ON” Position.
(D)
Layout and mark the area to
be cut using a chalk-line. Align
Pointer and Blade to chalk-line.
(F)
Start the Saw using the Engine Start
procedure in the engine manual.
Prior to operation of this machine the operator must determine the existence and
location of any subsurface features that may be hazardous or could damage the
equipment, (i.e. electric cable, natural gas line etc...)
CAUTION
(G)
With the engine running adjust
the throttle approximately half-
way.
(H)
For Wet Cutting, open Cooling
Supply Valve. Verify proper cool-
ing flow and adjust the water flow
on the Blade to a desired amount.
(I)
Move the throttle all the way for-
ward to “Fast” position.