MTS Series 505G2 SilentFlo Hydraulic Power Unit Model 505G2-30 - Manual (Page 69)

High Pressure Filter Kit
Model 505G2.20 - 505G2.30 SilentFlo™ HPU Accessories 69
Accessories
Contents High Pressure Filter Kit 69
Replacing the Pressure Line Filter Element 70
Accumulator Kit 71
Commoning Kit 73
Caster Kit 75
High Pressure Filter Kit
This section describes how to install the high pressure filter kit (part number
054-728-8XX).
To install the high pressure filter kit:
1. Ensure that system hydraulic pressure has been reduced to zero before
proceeding. To do this, turn off the hydraulic power unit and exercise the
actuator until it stops moving.
2. Remove the hose assembly and adapter connecting the high pressure port on
the manifold assembly to the high pressure output port.
3. Connect the 45° elbow to the output of the filter assembly. Connect the
straight tube to the input of the filter assembly.
High Pressure Filter Components
4. Connect the elbow to the high pressure port on the control manifold, and
connect the tube assembly to the elbow.
5. Mount the filter assembly and straight adapter to the tube assembly.
Control
Manifold
O-Ring
Adapter
Elbow
Filter Support
High Pressure
Output Port
High Pressure Hose 45° Elbow
High Pressure Port
Check
Valve
Reducer
Filter