Setting up the transducer interface, Setting up the transducer interface 59 – MTS SWIFT 30 Sensor User Manual
Page 59
Advertising
SWIFT 30 Sensors
Setting up the Transducer Interface
59
Setting up the Transducer Interface
Overview
Two different software configurations are used by the TI, depending on whether
you will be using the SWIFT sensor on the test track (spinning application) or in
the laboratory (non-spinning application). Angular transformation is required on
the test track only. If you are using the same transducer and TI for data collection
and simulation testing, you must change the software configuration before the TI
can be used for simulation testing.
Contents
Advertising