MTS SWIFT 30 Sensor - Manual (Page 89)

Test Track Vehicle
SWIFT 30 Sensors Installing the Transducer 89
Note If the anti-rotate assembly interferes with the mounting of the digital
inclinometer, use the alternate mounting location shown.
D. Place the digital inclinometer on the bracket and rotate the tire until the
inclinometer reads 0.0°, ±0.1° (or 90.0°, ±0.1° if the alternate position
is used).
E. Push the Bridge Zero button on the front of the TI box. The LED will
turn on for a few seconds, then start blinking rapidly. The Angle Zero
indicator will start blinking slowly.
F. Remove the digital inclinometer and level bracket.
G. Rotate the tire 90° in either direction.
H. Attach the level bracket in the same orientation as in Step 7C.
Insert the locking pin through the bracket and into the pin pilot hole on
the transducer.
Digital Inclinometer
–in this position
should read 0°, ±0.1°
Axes Icon
Insert Lock Pin
in Pilot Hole
Level Bracket
S30-20
Digital Inclinometer
(alternate location)
–in this position
should read 90°, ±0.1°
S20-21
Angle Zero
Switch and Indicator
Bridge Zero
Switch and Indicator