MTS Landmark System - Manual (Page 59)

c) Adjust Limits for the Test (p. 89)
d) Show Station Manager Scope and Meters for the Test (p. 90)
e) Minimize Station Manager (p. 91)
4. Run the Test
a) Open the MPX Application (p. 92)
b) Select the Test (p. 92)
c) If Necessary, Correct Any Resource Errors (p. 93)
d) Create a New Test Run (p. 93)
e) Run the Test (p. 94)
f) Review the Results (p. 95)
g) Generate a Report (p. 96)
h) Save the Test and Minimize MPX (p. 96)
5. Remove the Specimen
a) Remove Displacement Limits (p. 97)
b) Switch to Running Max/Min Displacement and Force Meters (p. 97)
c) If Appropriate, Remove the Intact Specimen (p. 98)
d) If Appropriate, Remove the Broken Specimen (p. 101)
6. Recover from a Tripped Limit
a) If Necessary, Recover from a Tripped Force Limit (p. 102)
b) If Necessary, Recover from a Tripped Displacement Limit (p. 105)
Prepare for Specimen Installation
Preparing for specimen installation consists of the following tasks:
a) Turn on the Station (p. 59)
b) Open Station Manager (p. 60)
c) Verify Calibration Files (p. 62)
d) Set Up Meters for Specimen Installation (p. 63)
e) Set Limits for Specimen Installation (p. 66)
f) Zero the Force Signal (p. 68)
g) Set Initial Tuning Parameters (p. 69)
Turn on the Station
1. Turn on the computer.
2. Turn on the controller.
MTS Landmark Test System Operation | 59
Running the Example HCF Test