MTS Landmark System - Manual (Page 95)

a) From the MTS TestSuite controller panel, reset the interlock if necessary.
b) Power up the HPU and HSM by clicking the Power Low and Power High buttons in sequence. Use
the button in the lower right corner of the Power Panel to access the HPU power buttons.
c) Click the Run button. The test will start. Run the test a total of five times to complete 1000 cycles.
Review the Results
Review the test results.
At the conclusion of the test, click any of the results tabs found in the MTS TestSuite main window for
test details.
MTS Landmark Test System Operation | 95
Running the Example HCF Test