Multiquip DCA20SPXU2 - Manual (Page 30)

page 30 — dCa20spxu2 servpro ® • operation and parts manual — rev. #0 (09/23/13)
Battery Cable installation
alWaYs be sure the battery cables (Figure 23) are
properly connected to the battery terminals as shown below.
The red cable is connected to the positive terminal of the
battery, and the black cable is connected to the negative
terminal of the battery.
Figure 23. Battery Connections
When connecting battery do the following:
1.
never connect the battery cables to the battery
terminals when the Control Power Switch is in the
on position. alWaYs make sure that the Control
Power Switch is in the OFF position when connecting
the battery.
2. Place a small amount of battery terminal treatment
compound around both battery terminals. This will
ensure a good connection and will help prevent
corrosion around the battery terminals.
Caution
alWaYs disconnect the negative terminal First and
reconnect negative terminal last.
NOTICE
If the battery cable is connected incorrectly, electrical
damage to the generator will occur. Pay close attention to
the polarity of the battery when connecting the battery.
Caution
Inadequate battery connections may cause poor
starting of the generator, and create other malfunctions.
alternator
The polarity of the alternator is negative grounding type.
When an inverted circuit connection takes place, the
circuit will be in short circuit instantaneously resulting the
alternator failure.
do not put water directly on the alternator. Entry of water
into the alternator can cause corrosion and damage the
alternator.
Wiring
Inspect the entire generator for bad or worn electrical wiring
or connections. If any wiring or connections are exposed
(insulation missing) replace wiring immediately.
piping and Hose ConneCtion
Inspect all piping, oil hose, and fuel hose connections for
wear and tightness. Tighten all hose clamps and check
hoses for leaks.
If any hose (
fuel or oil) lines are defective replace them
immediately.
inspectiOn/setup