Multiquip DCA20SPXU2 - Manual (Page 38)

page 38 — dCa20spxu2 servpro ® • operation and parts manual — rev. #0 (09/23/13)
Maintenance
JaCket Water Heater and internal BatterY
CHarger 120 vaC input reCeptaCles
This generator can be optionally equipped with a single
120 VAC, 15 amp input receptacle (Figure 43) located on
the output terminal panel.
The purpose of this receptacle is to provide power via
commercial power to the jacket water heater and internal
battery charger (Figure 44).
The receptacle will
onlY function when commercial power
has been supplied to it. To apply commercial power to the
receptacle, a power cord of adequate size will be required
(See Table 7).
When using the generator in
hot climates there is no
reason to apply power to jacket water heater. However, if
the generator will be used in cold climates it is always a
good idea to apply power to the jacket water heater at all
times. To apply power to the jacket water heater simply
apply power to the jacket water heater receptacle via
commercial power using an power cord of adequate size.
Figure 43. Battery Charger and Jacket Water
Heater Power Connections
CONNECT TO
EXTERNAL
120 VAC POWER
SOURCE
REFERENCE TABLE 7
FOR PROPER SIZE
EXTENSION CORD
BATTERY CHARGER/
JACKET WATER HEATER
120 VAC INPUT
RECEPTACLE
OUTPUT TERMINAL
PANEL ASSEMBLY
If the generator will be used daily, the battery should
normally not require charging. If the generator will be idle
(not used) for long periods of time, apply power to the
battery charger receptacle via commercial power using a
power cord of adequate size.
Figure 44. Jacket Water Heater/Battery Charger
NOTICE
To ensure adequate starting capability, always have
power applied to the generator's internal battery
charger.
BATTERY CHARGER
JACKET WATER HEATER
DC A MPER
ES
BATTERY CHARGER/
JACKET WATER HEATER
120 VAC INPUT
RECEPTACLE
OUTPUT TERMINAL
PANEL ASSEMBLY