Omnitron Systems Technology Cable Management Kit for 19-Module Chassis - Manual

Product Overview
The
iConverter Cable Management Kit organizes the routing of fiber and copper cables
providing a secure, clean and orderly installation. The Cable Management Kit is used with
the iConverter 19-Module Chassis.
Cable Management Kit consists of the following items:
• Cable Tray with six double-high cable clips
• Two extended mounting brackets with twelve 1/4” 4-40 flat head machine screws
• Two rack mounting screws 1/2” 10/32 truss head machine screws
Installation Procedure
1) Install/Remove Cable Clips
2) Install Extended Mounting Brackets
3) Install Cable Management Tray
4) Cable Management Tray Operation
1) INSTALL/REMOVE CABLE CLIPS
To install the Cable Clips on the Cable Management Tray, push the pin located on the bottom
of the Cable Clip into the hole on the Cable Management Tray until the pin is fully inserted.
To remove the Cable Clips, pinch the barbs on the pin located on the bottom of the Cable
Clip and pull up on the Cable Clip.
040-08095-001 10/12
Page 1
Omnitron Systems Technology * 140 Technology Dr. * Irvine, CA 92618
949-250-6210 tel * www.omnitron-systems.com
iConverter Cable Management Kit
Installation Guide
4) CABLE MANAGEMENT TRAY OPERATION
Modules can be inserted and/or removed from the chassis by loosening the thumbscrews
and swinging the Cable Management Tray downwards as illustrated in Figure 5.
Figure 5: Cable Tray Operation
Fiber optic and copper cables are routed through the cable clips on the Cable Management
Tray. Cables can be routed through both ends of the Cable Management Tray to maximize
the number of installed cables. A service loop in all cables must be provided to allow the
Cable Management Tray to swing downwards.