Omnitron Systems Technology Cable Management Kit for 19-Module Chassis - Manual (Page 2)

2) INSTALL EXTENDED MOUNTING BRACKETS
New Installation
Install the extended mounting brackets to the sides of the 19-Module chassis as illustrated
in the Figure 1. Use the screws included in the Cable Management Kit.
Figure 1: Installation of Extended Mounting Brackets
After the brackets are secured to the chassis, rack-mount the chassis in the equipment rack.
Once the chassis has been secured to the equipment rack, the Cable Management Tray can
be installed per Figure 3.
Upgraded Installation
On an existing 19-Module chassis with standard mounting brackets, remove and replace the
standard mounting brackets with the extended mounting brackets. Remove the six (6) screws
securing the standard mounting bracket to the chassis as illustrated in Figure 2.
Figure 2: Removal of Standard Mounting Brackets
Page 3
Install the new extended mounting bracket as illustrated in Figure 1. Use the screws included
in the Cable Management Kit.
After the brackets are secured to the chassis, rack-mount the chassis in the equipment rack.
Once the chassis has been secured to the equipment rack, the Cable Management Tray can
be installed per Figure 3.
3) INSTALL CABLE MANAGEMENT TRAY
Remove the lower rack mount screw, if installed, from the extended mounting bracket. It is
important to provide support to the chassis during this operation.
Figure 3: Removal of Rack Mount Screws
Secure the Cable Tray to the lower rack mount hole in the equipment rack using the existing
rack mount screw or the rack mount screws included in the Cable Management Kit as
illustrated in the Figure 4.
Figure 4: Cable Tray Installation
Page 2