Omnitron Systems Technology FlexPoint Powered Chassis 14-slot power-redundant chassis - Manual (Page 2)

2 Omnitron Systems Technology, Inc.
5. Loosen the 2 screws securing the power supply to the main chassis (see
illustration on page 6).
6. Remove the faulty power supply.
Hot Attachment of Power Supplies:
1. Unpack the power supply carefully. Inspect for any damages. If any damage
is observed, do not use the power supply and call (949) 250-6510 to report
the damage immediately and request a replacement unit.
2. Align the guide pins of the chassis with the holes in the power supply; tighten
the screws with a flat head screw driver.
3. Plug the AC cord to the back of the power supply.
4. Plug the AC cord to the AC wall outlet.
5. Watch and listen to the fan in the rear of the power supply start to run.
6. Watch and observe the LED in the front of the chassis indicating that the power
has been restored.
7. Save the packing material of the power supply for shipmnet of the faulty power
supply or for future reuse.
7
Safety Considerations
Warning
The operating description in this Instruction Manual is for use by qualified personnel only. To
avoid electrical shock, do not perform any servicing of this unit other than that contained in
the operating instructions, unless you are qualified and certified to do so by Omnitron Systems
Technology, Inc.
Caution
All user-required operations can be performed without opening the unit. Never attempt to
open or remove the cover or tamper with the unit or tamper with the power supply module.
Warranty
This product is warranted to the original purchaser against defects in material and workmanship
for a period of TWO YEARS from the date of shipment. A LIFETIME warranty may be obtained
by the original purchaser by REGISTERING this product with Omnitron within 90 days from
the date of shipment. TO REGISTER, COMPLETE AND MAIL OR FAX THE REGISTRATION
FORM INCLUDED WITH THIS INSTRUCTION MANUAL TO THE INDICATED ADDRESS.
Or you may register your product on the Internet at http://www.omnitron-systems.com. During
the warranty period, Omnitron will, at its option, repair or replace a product which is proven to
be defective.
For warranty service, the product must be sent to an Omnitron designated facility, at Buyer’s
expense. Omnitron will pay the shipping charge to return the product to Buyer’s designated
US address using Omnitron’s standard shipping method.
Limitation of Warranty
The foregoing warranty shall not apply to defects resulting from improper or inadequate use
and/or maintenance of the equipment by Buyer, Buyer-supplied equipment, Buyer-supplied
interfacing, unauthorized modifications or tampering with equipment (including removal of
equipment cover by personnel not specifically authorized and certified by Omnitron), or misuse,
or operating outside the environmental specification of the product (including but not limited
to voltage, ambient temperature, radiation, unusual dust, etc.), or improper site preparation
or maintenance.
No other warranty is expressed or implied. Omnitron specifically disclaims the implied
warranties of merchantability and fitness for any particular purpose.
Exclusive Remedies
The remedies provided herein are the Buyer’s sole and exclusive remedies. Omnitron shall
not be liable for any direct, indirect, special, incidental, or consequential damages, whether
based on contract, tort, or any legal theory.