Opticon PHL 7200 User Manual - Manual (Page 145)

OPTICON
User's manual
PHL-7000 series
6-2
6.1.2 Inserting a SIM Card
Note: If the battery is already installed, you must remove it before inserting the SIM card.
To insert the SIM card into the PDT:
1. Remove the 4 screws from the GSM End Cap with a screw driver, Torx type and size 8
(T8). And then remove the GSM End Cap.
Figure 6-1 Remove screws from End Cap
2. Insert the SIM card (with the gold side facing the inside of the slot) into the SIM slot.
Figure 6-2 Insert SIM card
3. Using 4 ~ 4.5 kgf-cm torque to fix the screws for GSM End Cap.
Note: Repeat the same steps to remove the SIM card from the SIM tray.