Opticon PHL 7200 User Manual - Manual (Page 62)

OPTICON
User's manual
PHL-7000 series
2-43
2.6 Power management
2.6.1 Suspend Mode
The PDT will go into a suspend mode when it is idle
for a period of time. The idle duration can be
customized using the Power control panel (refer to
Figure “Schemes Tab”) Suspend mode works and
looks just like you have turned the unit off. Press the
key to suspend the PDT, Press the key again
for the PDT to resume its Previous state.
Use the Battery power control panel to set the
duration to switch state to Suspend mode when
system using battery power. This will save battery
power when PDT is not in use.
Figure 2-24 Schemes Tab
Suspending:
The following conditions will suspend:
z
Press <Power> key while the unit is on.
z
The duration timer of item “Switch state to Suspend” expires, which indicates that
there has been no user activity for a specified of time.
z
The battery pack is almost empty.
z
Tap Start > Suspend
Figure 2-25 Suspend
Tap here to let PDT enter
into suspend mode