RKI Instruments SC-01 - Manual (Page 63)

Changing SC-01 Instrument Parameters • 63
Changing SC-01 Instrument Parameters
To make changes to parameters stored in the SC-01, use the
SC-01 Data Logger Management Program’s Set window. Follow
the steps below to make these changes.
1. Launch the SC-01 Data Logger Management Program.
2. If the Automatic Download selection box is selected,
deselect it.
3. Connect an SC-01 to the program. See “Downloading Data
from the SC-01” on page 19, instruction 1 through instruction
6, to connect an instrument to the program.
4. Once the connection is made, the Complete Download,
Instrument Information, and Power Off download
commands will be selectable. Click the Instrument
Information download command to retrieve the instrument
information from the SC-01. If you wish to download data
before making changes, click Complete Download instead
of Instrument Information.
Figure 54: Automatic Download Selection Box
Automatic Download Box, Deselected