RKI Instruments SC-01 - Manual (Page 9)

IrDA Downloading Cable • 9
Installing an IrDA Adapter Cable
After installing the Data Logger Management Program, connect
an IrDA/serial or IrDA/USB cable to your computer and follow
the manufacturer’s instructions for installing the cable on your
computer. Make sure the cable is compatible with your
Windows
®
operating system.
If you do not have instructions from the cable manufacturer for
installing your cable, see your Windows
®
documentation. In
general, you must go to the Control Panel and use the Add
Hardware Wizard to install the cable drivers.
Windows
®
Wireless Link Operation Note
When using an IrDA adapter cable and the SC-01 Data Logging
Software on a Windows
®
computer, it is necessary to make a
special setting in the Wireless Link Configuration window for
proper communication between the SC-01 and the Data Logger
Management Program. This must be done before attempting to
use the program. To make this setting, perform the following
steps:
1. Click Start in the Windows
®
Icon Tray.
2. If Control Panel is available to select in the Start menu,
select it. The Control Panel will appear.
If Control Panel is not selectable in the Start menu but
Settings is, select Settings, then select Control Panel. The
Control Panel will appear.
3. Double click on Wireless Link. The Wireless Link
Configuration window will appear.
4. Click on the Image Transfer tab.