SATEC BFM136 - Manual (Page 38)

‎Chapter 4 PAS Application Software Setting up Communications
38 BFM136 Branch Feeder Monitor
2. In the Protocol box, select the same communications protocol as you
have in your BFM136 . The default protocol setting in the BFM136 for
all ports is Modbus RTU.
For more information on configuring the protocol parameters, refer to the
PAS Getting Started guide.
Communicating through the Internet
If you are communicating via the Ethernet, define the IP address of your
BFM136 on the network.
1. On the Instrument Setup tab, select Internet Site.
2. Click on the Connection tab.
3. Click IP address and type in the IP address of your BFM136 . The
factory-set IP address is 192.168.0.203.
4. In the Protocol box, select Modbus RTU. The default host port 502 is set
automatically as you select the protocol.
5. In the Wait for answer box, adjust the time that PAS will wait for a
connection before announcing an error and the number of retries PAS
will use to receive a response from the device if communications fail.