Brother PE 300S - Manual (Page 23)

20
UPPER THREADING
CAUTION
Always make sure to thread the machine properly as
shown in the directions. If the machine is not threaded
properly, the thread could get stuck, needles could break
and bodily injury could result.
1. Raise the presser foot using the presser foot lever.
O
y [ W
y [ W
h ª ⁄
Ł
L fl
Ø
6
4
2
5
1
3
3. Set the thread spool. The thread end should come from the
bottom front of the spool. The spool cap closest to the thread
spool size should be used to hold the spool securely on the
spool post.
1 Spool cap
CAUTION
While sewing and embroidering, be sure that the spool pin
is pulled out and pushed toward the back of the sewing
machine.
2. Press the “NEEDLE POSITION” button to raise the needle to
the up position.
1
Contents
Setting Up
Basic Sewing
Machine
Operation
Utility Stitches
Embroidering
Maintenance
Troubleshooting
Error
Messages
Sewing Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory Card)