Embroidering, Before you begin, Attaching the embroidery foot “q – Brother PE 300S User Manual
Page 65
62
Embroidering
BEFORE YOU BEGIN
EMBROIDERING
J
1. Raise needle with the up-needle button. Turn power off.
2. Loosen the screw on the foot holder and remove foot holder.
3. Attach the embroidery foot. Screw back on tightly.
1
Screw
*
Make sure the needle clamp screw is also tightened.
1. Embroidery unit and memory cards (optional).
CAUTION
–
Do not touch the embroidery unit connectors. Doing so could cause damage to the machine.
–
Do not move the sewing machine while the embroidery unit is attached.
The embroidery unit could fall and cause injury.
–
Do not carry embroidery unit by the carriage or apply excessive
force to it, or you could cause damage.
–
Keep hands and other items away from the embroidery unit
carriage and embroidery hoop while they are in motion. Injury
could result.
1
Hoop holder
2
Carriage
3
Connector
–
Always store memory cards in the accessory case.
–
Always turn machine off before removing the embroidery unit or memory cards.
–
Please note that the small embroidery hoop (optional) will not work with certain pattern sizes and
sewing positions.
–
Please note that memory cards will not work with certain pattern sizes, and some memory cards are
not compatible with this machine.
2. Attaching the embroidery foot “Q”
CAUTION
–
Always make sure the power is off before changing feet.
Injury could result if the “START/STOP” button is accidentally pushed and the machine starts
running during this operation.
–
Do not use the embroidery foot “Q” for anything other than embroidery.
1
2
3
1