Brother PE 300S - Manual (Page 34)

31
Contents
Setting Up
Basic Sewing
Machine
Operation
Utility Stitches
Embroidering
Maintenance
Troubleshooting
Error
Messages
Sewing Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory Card)
CAUTION
Always make sure to turn the machine off and unplug it when changing presser feet. If the power
accidentally comes on, the machine might start running and bodily injury could result.
1. Push the “NEEDLE POSITION” button to raise the needle,
and then turn off the power.
2. Raise the presser foot lever.
3. Press the black button located at the back of the presser foot
holder to release the foot.
1 Presser foot holder
4. Place the presser foot pin directly below the holder-end and
lower the presser foot lever to attach the presser foot.
1 Holder-end
2 Foot pin
1
1
2
PRESSER FOOT
Changing the presser foot