Sulky VISION 1 SPB < 06/2009 - Manual (Page 53)

F aults Solutions
T HE UNIT DOES NOT LIT UP
T HE DRIVE RATE IS INCORRECT
F LOW RATE TEST
T HE UNIT COMES ON AS NORMAL , BUT THERE IS NO
RESPONSE FROM THE MS ACTUATORS
A REA COUNTER READING INCORRECT
Check - unit/power supply connections
- fuses supply line
Check - connection on unit
- sensor magnet clearance
- magnet rotation
- sensor wire continuity
(100Ω ± 10)
- 100-m coefficient
Check - c alibration factor
Carry out a new calibration test
Check - Fuses
Check - connection / machine
- working width
- Carry out another test over 100 metres.
- programmed flow rate
Informations
Informations
Informationen
GB
F aults - Solutions
53