Rockwell Automation 193/592-EC1/EC3/EC5 E3 and E3 Plus Solid-State Overload Relay - Quick Reference - Manual (Page 2)

2
Publication 193-QR003B-EN-P - October 2009
Important User Information
Because of the variety of uses for the products described in this publication, those responsible
for the application and use of this control equipment must satisfy themselves that all
necessary steps have been taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations, codes, and standards.
The illustrations, charts, sample programs and layout examples shown in this guide are
intended solely for purposes of example. Since there are many variables and requirements
associated with any particular installation, Rockwell Automation does not assume
responsibility or liability (to include intellectual property liability) for actual use based upon
the examples shown in this publication.
Rockwell Automation publication SGI-1.1, Safety Guidelines for the Application, Installation
and Maintenance of Solid-State Control (available from your local Allen-Bradley distributor),
describes some important differences between solid-state equipment and electromechanical
devices that should be taken into consideration when applying products such as those
described in this publication.
Reproduction of the contents of this copyrighted publication, in whole or part, without
written permission of Rockwell Automation, is prohibited.
ATTENTION
!
This guide does not replace the User Manual, publication
193-UM002_-EN-P, and is intended for qualified service personnel
responsible for setting up and servicing these devices. You must have
previous experience with and a basic understanding of electrical
terminology, configuration procedures, required equipment, and safety
precautions. The user manual can be downloaded from http://
literature.rockwellautomation.com.