Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 34)

34 Publication 1408-UM001B-EN-P - May 2008
Chapter 5 SCADA Applications
Configure DF1 Full-duplex
You need to use a RS232 to RS485 converter, like the 1761-NET-AIC or
B&B Electronics Converter – Model 485SD9TB.
1. Create a RS232 DF1 devices driver in RSLinx software.
2. Perform an Auto-configure.
3. Verify connections if Auto-configure fails.
4. Perform an RSWho to verify that RSLinx software is
communicating to the power monitor.
RSLinx software driver configuration is complete.
Configure RSLinx Software Driver Configuration for DH485
You need to use an RS232 to RS485 converter like the 1761-NET-AIC
converter or B&B Electronics Converter - Model 485SD9TB.
1. Open the RSLinx Launch Control Panel.
2. Start RSLinx software to run as normal application, not as
service.
3. Create a 1747-PIC/AIC+ Driver in RSLinx software.
4. Verify that the communication rate is the same as the
communication rate set for your power monitor.
5. Set the node address and maximum node address of RSLinx
Driver.
6. Perform an RSWho to verify that RSLinx software is
communicating to the power monitor.
7. Restart RSLinx software to run as service.