Rockwell Automation 1394 SERCOS Interface Multi-Axis Motion Control System Installation Manual - Manual (Page 30)

Publication 1394-IN002B-EN-P — February 2004
1-20 Installing Your 1394 SERCOS Interface System
7. Slide the slide-and-lock mechanism on the axis module to the left
until it locks into place.
Figure 1.13
Slide-and Lock Mechanism
8.
9. Install the lower fasteners for the system module and all axis
modules.
10. Attach the terminator to the last axis module. Slide it to the left
until it locks in place.
Figure 1.14
Attaching the Terminator
11. Tighten all mounting fasteners.
Status
DANGER RISK OF ELECTRICAL SHOCK. HIGH VOLTAGE MAY EXIST UP TO FIVE MINUTES AFTER REMOVING POWER.
SERCOS System Module
Slide-and-Lock
mechanism
If you: Do this:
Have more axis modules for this system
module
Go to step 4.
Do not have more axis modules for this
system module
Go to step 9.
Status
DANGER RISK OF ELECTRICAL SHOCK. HIGH VOLTAGE MAY EXIST UP TO FIVE MINUTES AFTER REMOVING POWER.
SERCOS System Module
Attach the
terminator
IMPORTANT
The terminator terminates the serial ring. The
1394 system will not operate without the
terminator.