Rockwell Automation 1420 PowerMonitor 500 - Manual (Page 23)

Rockwell Automation Publication 1420-UM001D-EN-P - September 2013
23
Chapter
3
Unit Configuration
Configure with the Display The PowerMonitor 500 unit provides menu-based configuration (programming)
by using its front panel display. The programming menus let you select
parameters to edit, select digits within parameters, and increase or decrease the
value of each digit.
Place the unit in Programming mode by pressing Program/select (8) for about
2 seconds. The front panel displays the PASSWORD? menu page 0 in Editing
mode. Enter the correct password by using the Up and Down arrows (the default
password is 0) and press Program/select. The front panel then displays the
CHANGE PAS menu page 10.
Refer to the programming flow chart beginning on page 26 for a view of the
organization of programming menus and sub-menus. Each page is identified with
a number. Menu page numbers end in zero, while sub-menu pages end in
1 through 9. For example, the Change Password page is menu 10. Likewise, the
Dmd page is menu 80, and the demand interval Time page is menu 82.
While you are programming the power monitor, the display items and control
buttons function one way when you are navigating between menu or sub-menu
pages, and another way when you are editing a menu page.
6
7
8
3
4
5
2
1