Rockwell Automation 1771-CFM Config. Flowmeter Installation Instructions - Manual

Publication 1771ĆIN043B-EN-P - July 2002
Configurable
Flowmeter Module
(Catalog Number 1771-CFM)
Use this document as a guide when installing a Configurable
Flowmeter module.
To See page
Important User Information 1
Calculate power requirements 4
Set the module operation jumpers 4
Set the input channel jumpers 5
Determine CFM module placement 6
Key the backplane connector 6
Install the module 7
Make connections to the field wiring arm 8
Ground the module 11
Configure the module 12
Interpret module status and input data 15
For this reference information See page
Diagnostics 16
Status indicators 16
Specifications 18
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Rockwell Automation be
responsible or liable for indirect or consequential damage resulting
from the use or application of these products.
Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Rockwell Automation does not
assume responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.
This icon is used when
additional information
is available in the
Configurable Flowmeter
Module User Manual,
publication 1771Ć6.5.99.
Important User Information
Installation Instructions
Contents