Rockwell Automation 1756-EN3TR ControlLogix EtherNet/IP Communication Module Installation Instructions - Manual (Page 11)

11
Publication 1756-IN612B-EN-P - December 2009
Use RSLinx Classic or RSLogix 5000 Software
Follow the procedures outlined in the online help that accompanies this
software to set the network address.
Install the Module
To install the module, follow this procedure.
1. Align the circuit board with top and bottom guides in the chassis.
31588-M
WARNING
When you insert or remove the module while backplane power is on, an
electrical arc can occur. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
Repeated electrical arcing causes excessive wear to contacts on both the
module and its mating connector. Worn contacts may create electrical
resistance that can affect module operation.