Install or remove the module under power, 17 publication – Rockwell Automation 1756-EN3TR ControlLogix EtherNet/IP Communication Module Installation Instructions User Manual
Page 17
17
Publication
1756-IN612B-EN-P - December 2009
The display then alternates between OK and port link status for both
ports.
LNK1 LNK2 OK
TM
10/100 BASE T
OK
LNK1
LNK2
Install or Remove the Module Under Power
You can install or remove this module while chassis power is applied.
When you insert or remove the module while backplane power is on, an
electrical arc can occur. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
Repeated electrical arcing causes excessive wear to contacts on both the
module and its mating connector. Worn contacts may create electrical
resistance that can affect module operation.
Be sure that power is removed or the area is nonhazardous before proceeding.
Repeated electrical arcing causes excessive wear to contacts on both the
module and its mating connector. Worn contacts may create electrical
resistance that can affect module operation.
WARNING