Rockwell Automation 1756-EN3TR ControlLogix EtherNet/IP Communication Module Installation Instructions - Manual (Page 12)

12
Publication 1756-IN612B-EN-P - December 2009
2. Slide the module into the chassis, making sure the module backplane
connector properly connects to the chassis backplane and noting that
the module is properly installed when it is flush with the power supply
or other installed modules.
31589-M
Wire the Ethernet Connector
Use an RJ45 connector to connect
to the EtherNet/IP network. Wire
the connector as shown.
For detailed EtherNet/IP
connection information, see the
EtherNet/IP Media Planning and
Installation Manual, available from
the Open DeviceNet Vendor
Association (ODVA) at
http://www.odva.org .
RJ 45
8
1
8 ------ NC
7 ------ NC
6 ------ RD-
5 ------ NC
4 ------ NC
3 ------ RD+
2 ------ TD-
1 ------ TD+