Rockwell Automation 1792-IB8XOB8PLP INSTL INSTR ARMORBLOCK LP 8/8 - Manual (Page 11)

ArmorBlock-LP 8 Input/8 Output Module 11
Publication 1792-5.8 – December 1997
Sensor Source Voltage
Current
Minimum 13V dc @ 400mA out and
DeviceNet power = 15V dc
50mA per point, 0.4A total per module
Output Specifications
Output Power Supply Note: In order to comply with CE Low Voltage Directives,
you must use a Safety Extra Low Voltage (SELV) or a
Protected Extra Low Voltage (PELV) power supply to
power the outputs of this module.
Outputs per Block 8 Sourcing Outputs – labeled 2, 4, 6 and 8
Output Voltage Range 19–30V dc
On-state Current Maximum 1.0A per output
On-state Voltage Maximum 3V dc at rated current
Module Current (all outputs on) 8.0A per module
Off-state Leakage Current 1.5mA maximum per output
Specifications continued on next page.
General Specifications
Indicators Network Status – red/green
Module Status – red/green
Sensor Supply Status – green
Module Power Supply Status – green
Short Circuit Sensor – red
I/O Status – yellow
Communication Rate in Baud 125k, 250k, 500k software selectable
DeviceNet Power Voltage
Current
11.0 – 25.0V dc
100mA (no powered sensors); 500mA (full sensor load)
Specifications continued on next page.