Rockwell Automation 1784-PCIDS DeviceNet PCI Communication Interface Card - Manual (Page 46)

6-2 Use the DeviceNet Test Application to Verify the Configuration
Publication 1784-IN004E-EN-P - April 2005
Start the Test Application
The test application is automatically installed as part of the driver installation procedure.
To start the test application, click Start
⇒Programs ⇒Rockwell Software ⇒IOLinx
⇒IOLinx for DeviceNet ⇒DeviceNet Test.
If the driver cannot establish communication with the module, an error message is displayed.
Configure the Port
You must configure the port the first time you use a 1784-PCIDS card.
To configure the port, follow these steps:
1. Select Configure Port... from the Setup menu.
2. Select Allen-Bradley 1784-PCIDS from the DeviceNet Driver Selection screen.
3. Click on Select.
4. Set Node Address (0 - 63).
5. Set Baud Rate (125/250/500 kbs).
6. Click OK. You see a dialog box that tells you operation was successful, followed by a
similar message box that tells you that the port has been configured.