Rockwell Automation 1794-IE8H, Series B FLEX I/O 8 Input Hart Analog Module Installation Instructions - Manual (Page 7)

FLEX I/O 8 Input HART Analog Module 7
Publication 1794-IN108D-EN-P - January 2014
About the Module
The HART analog modules can be used with ControlNet, Ethernet and
Profibus-DP (1794-APBDV1 only) adapters. When using the Series B module
with a Series B profile, you must have a ControlNet adapter Revision 5.1 or
higher or an Ethernet adapater Revision 4.2 or higher.
For this scenario (Series A profile with a Series B Module), the data maps
(input, configuration and extended configuration) are designated as Series A
Mode. Note, all other data maps are for a Series B module with a Series B
profile.
Only use the series A configuration when replacing a series A module with a
series B module. If you access the Series A configuration while using the
module as a series B unpredictably operation of the module may occur.
Install the Module
Read this for information about how to install the module. The module must
be used with a 1794-TB3G or 1794-TB3GS terminal base unit.
ATTENTION During mounting of all devices, be sure that all debris (such as metal chips or
wire strands) is kept from falling into the module. Debris that falls into the
module could cause damage on power up.
40231
3
4
7
1
2
6
5
8
Label here or under here